Article on: Manual Boost Controller - Dawes Device

I thought I would post this because there are many newbies (like me) that are not sure about installing a MBC.

Here is my Dawes MBC:

Here is the "T" that you are looking for. It is on the left side, right under the Intercooler:

Pull all the hoses off the "T" and also pull the small (3 inch hose) off of the wastegate:

Here is a pic of the 3 inch hose uninstalled from the wastegate and "T":

Now take that long hose to the left and stick a bolt in it and tie it back to something. I just ziptied it to something.

Install the MBC. Here is a pic of the bottom part attached to the stock hose:

Here is a pic that shows the hose on the MBC connected to the wastegate, It is hard to read but the top arrow say MBC:

Here is a top angle so you can see how the hose is ran:

After you are finished, This is everything that should have been removed:

(The ISDC cannot be held responsible for any modifications that adversely effect the warranty of your car.)